4/10/2023 0 Comments Sms sender and receiverIf you don't see an option to turn on MMS Messaging or Group Messaging on your iPhone, then your carrier might not support this feature. If you’re trying to send group MMS messages on an iPhone, go to Settings > Messages and turn on MMS Messaging.Check with your carrier to see if the type of message you’re trying to send, like MMS or SMS, is supported.If you turn on Wi-Fi Calling, you can send SMS messages over Wi-Fi. To send an SMS message, you need cellular network connection. To send a message as iMessage or MMS, you need a cellular data or Wi-Fi connection. Under “Advanced Settings”, “Send and Receive Messages over the same connection” must be checked.To define a “transceiver” connection, ensure that the following settings are applied in the properties for the SMPP connection: If you wish to only use explicit routing to route messages via this connection, add the text “explicit” to the “Preferred SMSC connection for” list, so the list will no longer be blank. The last setting may cause problems for configurations where you only want to route messages for sending via this connection explicitly (as described in “Routing SMS Messages to a Specific SMSC Route”). Either “Support any outbound message traffic” must be checked, or there must be at least one entry in the “Preferred SMSC connection for” list.In versions prior to 2011.08.11, the following is also required: To define a connection with separate “sender” and “receiver” connections, ensure that the following settings are applied in the properties for the SMPP connection: The “Preferred SMSC Connection for” list should be empty.“Support any outbound message traffic” must not be checked.“Receive SMS Messages” must be checked.Under “Advanced Settings”, “# Transmitter Sessions” should be set to 0 and “# Receiver Sessions” should be set to 1.“Receive SMS Messages” must be checked.To define a “receiver” connection only, ensure that the following settings are applied in the properties for the SMPP connection: Under “Advanced Settings”, “Send and Receive Messages over the same connection” must not be checked.“Receive SMS Messages” must not be checked.To define a “sender” connection only, ensure that the following settings are applied in the properties for the SMPP connection: There are also special configurations where you may need to configure a connection to be only a “sender”, or only a “receiver”. Separate “sender” and “receiver” connections generally offer the best performance under extreme loads, however your provider may wish for you to use a “transceiver” connection to reduce the connection overhead on their server. The type of connection that you use will depend on the preferences and policies of your SMPP service provider. When defining an SMPP connection in NowSMS, it is possible to configure the connection to be only a “sender”, only a “receiver”, separate “sender” and “receiver” connections, or a single “transceiver” connection. A “transceiver” connection is allowed to both send and transmit messages over the same connection.If you see the ESME_RINVBNDSTS error when submitting messages, check to see that NowSMS has not been inadvertantly configured for a receiver only connection. Any attempt to receive messages over this connection will usually result in the error ESME_RINVBNDSTS (Incorrect BIND Status for given command). A “receiver”, or “receive only”, connection is not allowed to transmit messages over the connection, it can only receive messages.(Some SMPP servers will still deliver SMPP delivery receipt messages over a “sender” connection.)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |